Look S95 Manual De Montaje página 15

GB
INSTALLING THE BOTTOM BRACKET ASSEMBLY
Check that the threads are free of paint and are clean.
Follow the manufacturer's assembly, adjustment and maintenance instructions.
We recommend that a work stand be used to fit the bottom bracket assembly, holding the frame
by the front and rear wheel attachments.
INSTALLING THE SEATPOST
Your frame is installed with a special profiled
«E-Post» seatpost and a set of height adjust-
ment spacers (including the vibration damp-
ing spacer rings).
The seat attachment device patented by
LOOK:
- Enables continuous forward / backward
displacement at the same time as the seat
tilt angle adjustment, due to a groove that in-
creases the total fore/aft adjustment range
of the seat to 50 mm),
- Due to the arrangement of its carbon seat
rail clamps, a super low profile position of
the seat, a significant weight saving and im-
proved aesthetics.
NOTE: the frame is delivered with a
very long seat tube that must be cut to
install the seatpost. The procedure to be
followed for this operation is described
after the seat assembly process on the
post that must be done first.
28
Picture 1
WARNING:
BEFORE TAKING THE SEAT OFF YOUR CYCLE,
MEASURE THE SEAT HEIGHT «A» AS SHOWN ON
PHOTO 1 ABOVE (from the centerline of the pedal
assembly to the seat).
Installing the seat on the seatpost
1 – Put the SLIDE (4) into position on the
SEATPOST head (8).
2 – Put the LOWER CARRIAGE (3) into
position on the SLIDE + SEATPOST assembly.
3 – Place the UPPER CARRIAGE (2) on the
LOWER CARRIAGE (3) such that the grooves
are perpendicular.
4 – Insert the SCREW (7) in the SCREW
WASHER (6) then in the OBLONG WASHER
(5), checking that the curved faces 2 of the
washers are free to slide.
5 – Insert the 3 elements in the ROD
+ SLIDE + LOWER CARRIAGE + UPPER
CARRIAGE assembly and screw into the nut
(1).
6 – Bring the seat rails on the LOWER
CARRIAGE (3), then turn the UPPER CARRIAGE
(2) so that the grooves are parallel.
7 – Adjust the seat horizontally using
a level and then make the fine adjustment
according to your preferences.
8 – Tighten the two assemblies using the
SCREW (7) to the recommended tightening
torque of 22 Nm, and using a 6 mm Allen key.
1
2
3
4
5
6
8
7
1 : Nut
2 : Upper carriage
3 : Lower carriage
4 : Slide
5 : Oblong washer
6 : Screw washer
7 : Screw
8 : Seat post
CAUTION: Never go beyond the» STOP»
indication.
Do not glue any stickers onto carbon
elements
Cleaning: Use soapy water only.
GB
29