Multi Wireless Master Unit; (Multi, Master Canon) - Rollei 58 Instrucciones

Multi Wireless MASTER Unit

(Multi, MASTER Canon)

Press the [Flash mode select button] to set the MASTER light as Mulit mode . You
can set up each SLAVE unit in different flash light ratios . Use the MASTER unit to
finish all settings (SLAVE unit and MASTER unit is the same) .
1 . Press the [Parameter setting button] for a long
time to set it as Canon MASTER unit .
2 . Press down the [Flash mode select button] to
set Multi mode .
3 . Press down the [Wiress Parameter select
button] until <RATIO> twinkles .
4 . Select the flash light ratio. Rotate the dial to set the flash light ratio:
<RATIO>, <RATIO A: B> or <RATIO A: B: C> . Select the flash light ratio
<RATIO> . This means three SLAVE units will take the same mode and power
output as the MASTER unit . Press Multi mode, set the power output: Select the
flash light ratio <RATIO A: B> . This means group A/B flashes and the power
output needs to be set for each single flash of the group . Select the flash light
ratio <RATIO A: B: C> . This means three groups are all on and will flash, but the
power output needs to be adjusted for each single flash .
5 . Set the flash output <RATIO A: B> or <RATIO A: B: C>
Press the [Parameter setting button] until the frequency data twinkles . Rotate
the dial to adjust the frequency .
Press the [Parameter setting button] until the number of flashes twinkles . Rotate
the dial to adjust the number .
Press the [Parameter setting button] until SLAVE account A and group A power
twinkles . Rotate the dial to adjust the power of group A .
Press the [Parameter setting button] until SLAVE account B and group B power
twinkles . Rotate the dial to adjust the power of group B .
Press the [Parameter setting button] until SLAVE account C and group C power
twinkles . Rotate the dial to adjust the power of group C .
75