AKG WMS40 Modo De Empleo página 12

ON: Power to the transmitter is on.
MUTE: The signal delivered by the
microphone or instrument is
muted while power and the RF
carrier frequency remain on. This
prevents the receiver from re-
sponding to interference from
other transmitters.
OFF: Power to the transmitter is off.
2 Status LED: Indicates battery status.
LED flashes momentarily upon
switching ON and extinguishes:
batteries are OK.
LED lights constantly: batteries will
be dead in about 50 minutes.
3 Audio input: 3-pin mini XLR
connector with both mic and line
level pins that automatically match
the connector pinout of the recom-
mended AKG microphones or
optional MKG/L guitar cable.
4 Antenna: Permanently connected,
flexible antenna.
12
2.6 Rear Panel Controls (Refer to fig. 2)
5 Belt Clip for fixing the transmitter
to your belt.
6 Battery Compartment Lid: Refer
to section 3.2 Inserting Batteries.
7 MIC/LINE: This slide switch sets
the audio input either to micropho-
ne level ("MIC" position) or line level
("LINE" position).
8 GAIN: This rotary pot matches the
sensitivity of the transmitter's audio
section to the level of the connec-
ted microphone or instrument.
9 Carrier Frequency Label: The
label on the transmitter rear panel
indicates the carrier frequency,
color code (receivers with the same
carrier frequency are marked with
the same color), and approval
marks of your transmitter.
5
7
6
2 x 1.5V
+ –
Fig. 2: Rear panel controls
9
8