AKG WMS40 Modo De Empleo página 15

A positive supply voltage of 3.8 V for
condenser microphones is available on
pin 3.
Important: Please note that AKG cannot
guarantee that the PT 40 bodypack
transmitter will work perfectly with
products from other manufacturers
and any damage that may result from
such use is not covered by the AKG
warranty scheme.
1. Remove the battery compartment lid.
2. Set the MIC/LINE switch (7) to "MIC"
and use a small screwdriver to set the
GAIN control (8) to a position halfway
between full CCW and full CW.
3. Plug the mini XLR connector on the
cable of your microphone into the
audio input connector (3) on the
bodypack transmitter.
4. Set the on/off switch (1) to "ON" to
switch power to the transmitter on.
5. Switch power to the receiver and
your sound system or amplifier on.
Check the setting of the VOLUME
control on the receiver:
Fully CCW if you connected the
receiver to a microphone input.
Fully CW if you connected the
receiver to a line input.
6. Talk or sing into the microphone and
set the levels on your mixer or ampli-
fier referring to the appropriate
instruction manual or by ear.
3.3.2 Connecting an Instrument (fig. 4)
1. Remove the battery compartment lid.
2. Set the MIC/LINE switch (7) to "LINE"
and use a small screwdriver to set the
GAIN control (8) to a position halfway
between full CCW and full CW.
3. Plug the 1/4" jack plug on the option-
al MKG/L guitar cable to the output
jack on your instrument and the mini
XLR connector on the guitar cable
3
7
Fig. 4: Connecting an instrument
8
15