Installing The Drain Pipe - Sanyo SPWXDR124GH56A Manual Del Usuario

3-4. Installing the Drain Pipe

(1) Prepare a standard hard PVC pipe (O.D. 32 mm)
for the drain and use the supplied drain hose and
hose band to prevent water leaks.
The PVC pipe must be purchased separately. The
GB
unit's transparent drain port allows you to check
drainage. (Fig. 3-6)
FR CAUTION
●
Insert the drain pipe until it contacts the socket
as shown in Fig. 3-6, then secure it tightly with
DE
the hose band.
●
Do not use adhesive when connecting the sup-
plied hose.
Reasons: 1. It may cause water to leak from the
IT
connection. Since the connection is
slippery just after the adhesive has
been applied, the pipe easily slips off.
PT 2. The pipe cannot be removed when
maintenance is needed.
●
Do not bend the supplied drain hose 90° or
more. The hose may slip off.
GR
●
Align the hose bands with the end of the hose.
Tighten the hose band firmly. Make sure that
the bead is not covered by the hose band.
(Fig. 3-6)
ES
(2) After checking the drainage, wrap the supplied
packing and drain pipe insulator around the pipe.
(Fig. 3-7)
CAUTION
NOTE
Make sure the drain pipe has a downward gradient
(1/100 or more) and that there are no water traps.
CAUTION
DC̲Inverter̲Eng.indd 22 DC̲Inverter̲Eng.indd 22
Tighten the hose clamps
so their locking nuts face
upward. (Fig. 3-6)
●
Do not install an air bleeder
as this may cause water to
spray from the drain pipe
outlet. (Fig. 3-8)
Hose band
Supplied
Connection pipe
drain hose
(drain port)
Align the hose
band with the end
of the pipe
Bead
Fig. 3-6
Drain insulator (supplied)
Vinyl clamps
Fig. 3-7
Air bleeder prohibited
Fig. 3-8
22
Hard PVC
socket
Hard PVC pipe
VP-25
VP-25
(Field supply)
(Field supply)
PVC adhesive
Packing
(supplied)
2007/07/25 13:21:37 2007/07/25 13:21:37