Installing The Drain Hose - Sanyo SPWXDR124GH56A Manual Del Usuario

Left or left-rear tubing
(1) Pass the tubing and drain hose into the rear of
the indoor unit. Provide sufficient length for the
connections to be made.
Next, bend the tubing with a pipe bender, and
connect them.
(2) After performing a leak test, wrap the refrigerant
tubing and drain hose together with insulating
tape, as shown in the figure at right.
Then fit the tubing into the tubing storage space in
the rear of the indoor unit and clamp in place.
(3) Adjust the indoor unit so that it is securely
mounted on the rear panel.

3-12. Installing the Drain Hose

a) The drain hose should be slanted downward to the
outside. (Fig. 3-32)
b) Never allow water traps to be formed in the course
of the hose.
c) If the drain hose will run in the room, insulate* the
hose so that chilled condensation will not damage
furniture or floors.
* Foamed polyethylene or its equivalent is
recommended.
WARNING
DC̲Inverter̲Eng.indd 27 DC̲Inverter̲Eng.indd 27
Do not supply power to the
unit or operate it until all
tubing and wiring to the
outdoor unit are completed.
Fig. 3-30
Insulating tape
Drain hose
Fig. 3-31
Indoor unit
Fig. 3-32
27
Insulation
GB
Refrigerant tubing
FR
Rear panel
Inter-unit wiring
DE
IT
PT
Slant
GR
Refrigerant
tubing
ES
2007/07/25 14:04:45 2007/07/25 14:04:45