Sanyo SPWXDR124GH56A Manual Del Usuario página 30

(5) Before suspending the indoor unit, remove the 2
or 3 screws on the latch of the air-intake grilles,
open the grilles, and remove them by pushing
the claws of the hinges as shown in Fig. 3-41.
Then remove both side panels sliding them along
GB
the unit toward the front after removing the 2
attachment screws. (Fig. 3-42)
(6) Carry out the preparation for suspending the
indoor unit. The suspension method varies
FR
depending on whether there is a suspended
ceiling or not. (Figs. 3-43 and 3-44)
(7) Suspend the indoor unit as follows:
a) Mount 1 washer and 2 hexagonal nuts on each
DE
suspension bolt as shown in Fig. 3-45.
IT
PT
GR
ES
DC̲Inverter̲Eng.indd 30 DC̲Inverter̲Eng.indd 30
Pull out the
air-intake grille
pushing claws
of the hinges
Screw
Latch
Air-intake grille
Fig. 3-41
Slide toward
front side
Side panel
Fig. 3-42
Unit
Fixture
Fig. 3-43
Unit
Fig. 3-44
Washer
(supplied)
Suspension bolt
Fig. 3-45
30
Hinge
Suspension bolt
(field supply)
Ceiling surface
Washer (supplied)
Double nut
(field supply)
Suspension bolt
(field supply)
Washer (field supply)
Washer (supplied)
Double nut
(field supply)
Ceiling
surface
Nut
(field supply)
2007/07/25 13:21:40 2007/07/25 13:21:40