Sanyo SPWXDR124GH56A Manual Del Usuario página 46

Tabla de contenido

Publicidad

(5) Use shielded wires for inter-unit control wiring
(c) and ground the shield on both sides,
otherwise misoperation from noise may occur.
(Fig. 5-4)
Connect wiring as shown in Section "5-3.
GB
Wiring System Diagrams".
WARNING
FR
DE
When connecting each power wire to the terminal, fol-
low the instructions on "How to connect wiring to the
terminal" and fasten the wire securely with the termi-
nal screw.
IT
How to connect wiring to the terminal
■ For stranded wires
PT
(1) Cut the wire end with cutting pliers, then strip the
insulation to expose the stranded wire about 10
mm and tightly twist the wire ends. (Fig. 5-5)
(2) Using a Phillips head screwdriver, remove the
GR
terminal screw(s) on the terminal plate.
(3) Using a ring connector fastener or pliers, securely
clamp each stripped wire end with a ring pressure
terminal.
ES
(4) Put the removed terminal screw through the ring
pressure terminal and then replace and tighten the
terminal screw using a screwdriver. (Fig. 5-6)
DC̲Inverter̲Eng.indd 46
DC̲Inverter̲Eng.indd 46
Loose wiring may cause
the terminal to overheat
or result in unit malfunc-
tion. A fire hazard may also
occur. Therefore, ensure
that all wiring is tightly
connected.
Shielded wire
Ground
Fig. 5-4
Stranded wire
Fig. 5-5
Special
Screw
washer
Ring pressure
terminal
Terminal plate
Wire
Fig. 5-6
46
Ground
Ring
pressure
terminal
Screw and
Special washer
Ring
pressure
terminal
Wire
2007/07/25 13:21:44
2007/07/25 13:21:44

Publicidad

Tabla de contenido
loading

Tabla de contenido