Publicidad
Idiomas disponibles
Idiomas disponibles
FITTING THE BATTERIES.-
This
monitor
Alkaline
Batteries.
batteries, remove the rear cover on
the monitor, Fig.1, and carefully insert
the two "AAA" type batteries into the
battery compartment making sure that
the
battery's
(matching the battery's «+» terminal
with the «+» sign inside the battery
compartment, and the «-» terminal
with the «-» sign). Close the cover.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
The monitor will switch itself off
automatically
if
motionless for 4 minutes.
If you see the words BATT LOW
flashing on the display screen, change
the batteries immediately.
Important:
components in special containers,
Fig.2.
1.- FITTING THE ELECTRONIC
MONITOR.-
Place the monitor (500N) in the
direction of the arrow sliding the
monitor on the holding plate (M) Fig.3
and fix it with the screw (71).
Connect the terminal (502N) of the
cable sticking out of the main body (A)
in terminal (72) of the rear part of the
monitor (500N) Fig.3.
uses
two
1.5
To
fit
polarity
is
correct
the
unit
remains
Deposit
electronic
English
2.-SETTING THE TIME ON THE
volt
MONITOR.-
the
With the machine stopped and the
clock on the screen, press and hold the
right key for 6 seconds
until the set up menu
for CLOCK appears,
use the left key to
select a 24h or 12h
hour format and press
the
confirm.
Next the hour digits will flash, use the
left key to select and press the right
key to confirm.
Next the minute digits will flash, use
the left key to select and press the
right key to confirm.
Press and hold the left key for a few
seconds to pass to the main screen.
3. SETUP.-
With the machine stopped, press the
left button and without
displaying
screen clock, press
the right button for 6
seconds and this will
access
menu.
The word TIME will appear on the
screen, select this with
the right button and
confirm the time using
the left button.
6
right
key
to
the
on-
the
setup
Publicidad
