Setting The Pump; Factory Settings; Control Panel - Grundfos UPE 2000 Serie Manual Del Usuario

7. Setting the pump

For the setting of the pump, use:

• Control panel.

• R100 remote control.
• Bus communication
(not described in detail in these instructions.
Contact Grundfos).
The following table shows the application of the indi-
vidual operating units and in which section the func-
tion has been described.
Function
Proportional pressure con-
trol
Constant pressure control
Setting of pump head
Max. curve duty
Min. curve duty
Constant curve duty
Temperature influence
Resetting of fault indica-
tions
Activation/deactivation of
pump buttons
Allocation of pump number
Reading various data
Start/stop
"-" = not available with this operating unit.

7.1 Factory settings

Pump type Control mode
UPE xx-40 Proportional pressure
UPE xx-60 Proportional pressure
UPE xx-80 Proportional pressure
16
7.2 Control panel
The control panel, fig. 21, incorporates the following:
• Buttons, "+" and "–", for setting.
• Light fields, yellow, for indication of control mode
• Indicator lights, green and red, for operating and
Fig. 21
7.2.1 7.7.1
7.2.1 7.7.1
7.3 7.5.1
7.3.1 7.5.2
7.3.2 7.5.2
- 7.5.2
- 7.7.2
7.2.1 Setting of control mode
7.3.4 7.5.3
Description of function, see section 6.1 Control
modes.
- 7.7.3
When the buttons "+" and "–" are pressed simultane-
- 7.7.4
ously, the light fields will indicate the selected control
mode:
7.6.1-
-
7.6.6.
7.3.3 7.5.2
Pump head
If the buttons are pressed for more than 5 sec., the
control mode will change over to constant pressure
1.8 metres at maxi-
and proportional pressure respectively.
mum flow, see fig. 23
Note:
3 metres at maximum
flow, see fig. 25
If the pump has been set to constant curve duty and
4 metres at maximum the buttons "+" and "–" are pressed simultaneously,
flow, see fig. 27
the following applies:
• less than 5 sec.:
• more than 5 sec.:
At high liquid temperatures, the pump may
be so hot that only the buttons should be
touched to avoid burns.
and pump head.
fault indication, see section 6.6 Indicator lights.
Light fields
Indicator lights
Light fields
Top + bottom
light fields flashing
Middle light field(s)
flashing
The light fields will not indicate the selected con-
trol mode.
The control mode will not be changed.
Buttons
Control mode
Proportional pressure
Constant pressure