Changing The Tv Screen Settings - Alpine DHA-S680 Manual De Operación

Default Settings (SET UP)
ENT

Changing the TV screen settings

Use the procedure described below to set the
output screen according to the type of TV
monitor being used.
NOTE
When the settings are changed, the old settings are
overwritten. Make a note of the current settings before
making changes. The settings are not cleared even
when the vehicle's battery is disconnected.
1
In the stop mode, press the SET button for at
least 2 seconds.
The default setting menu appears.
NOTE
This operation cannot be performed in the PRE-STOP
mode.
2
Use the Joystick to select "TV SCREEN", then
press the ENT button.
22
-EN
All manuals and user guides at all-guides.com
DN
CLR
0
9
3
Use the Joystick to make the selection, then
press the ENT button.
4 : 3 LETTERBOX
Select this when connected to a conventional 4:3
size (normal TV aspect ratio) monitor. There may
be black stripes visible at the top and bottom of
the screen. The width of these stripes will
depend upon the original aspect ratio of the
theatrical release of the movie.
4 : 3 PAN-SCAN
Select this when connected to a conventional 4:3
size monitor. The picture will fill the entire TV
screen. However, due to the mismatch in aspect
ratio, parts of the movie at the extreme left and
right sides will not be visible.
16 : 9 WIDE
Select this when connected to a wide screen TV.
This is selected upon shipment from the factory.