Changing The Down Sampling Setting - Alpine DHA-S680 Manual De Operación

Default Settings (SET UP)
ENT
Changing the down sampling
setting
Converts linear PCM (LPCM) voice signals
recorded on the DVD disc to downsampling 48
kHz/16 bit digital signals and outputs them from
the optical cable.
NOTE
When the settings are changed, the old settings are
overwritten. Make a note of the current settings before
making changes. The settings are not cleared even when
the vehicle's battery is disconnected.
1
In the stop mode, press the SET button for at
least 2 seconds.
The default setting menu appears.
NOTE
This operation cannot be performed in the PRE-STOP
mode.
2
Use the Joystick to select "DOWN SAMPLING",
then press the ENT button.
26
-EN
All manuals and user guides at all-guides.com
3
Move the Joystick up and down to choose "ON"
or "OFF" and, then press the ENT button.
ON
The digital signals recorded on the DVD disc with
96 kHz/24bit, 96 kHz/20bit, 96 kHz/16bit, 48 kHz/
24bit, 48 kHz/20bit sampling are converted into
digital signals with 48 kHz/16bits sampling for
output from the optical cable.
Set to ON at time of shipment from factory.
OFF
The digital signals recorded on the DVD disc with
96 kHz/24bit, 96 kHz/20bit, 96 kHz/16bit, 48 kHz/
24bit, 48 kHz/20bit sampling are not converted
into digital signals with 48 kHz/16bits sampling.
They are not output from the optical cable.
NOTE
Press the RTN button to return to the previous screen.
4
Press the SET button for at least 2 seconds.
The settings are stored and the set up mode is
canceled.