Kit Preparation - Metra 99-7345B Instrucciones De Instalación

DASH DISASSEMBLY
7. Remove (6) Phillips screws securing
the radio trim panel and then remove.
(Figure G)
8. Remove (4) Phillips screws, (2 above and
2 below) from the radio assembly, then
unplug and remove the radio. (Figure H)
Continue to Kit Preparation
(CONT.)
(Figure G)
(Figure H)

KIT PREPARATION

1. Remove (3) Phillips screws securing the
vent on the factory radio trim panel and
then remove. (Figure A)
2. Install the factory vent to the radio trim
panel using (3) #8 x 3/8" Phillips pan
head screws supplied. (Figure B)
Continue to Kit Assembly
(Figure A)
(Figure B)
REV. 5/15/2018 INST99-7345B
3