Kit Assembly - Metra 99-7345B Instrucciones De Instalación

1. Secure the pocket to the radio brackets using (4) #8 x 3/8" Phillips truss
head screws supplied. (Figure A)
2. Remove the metal DIN sleeve and trim ring from the aftermarket radio.
3. Secure the radio to the pocket/bracket assembly using the screws
supplied with the radio. (Figure A)
4. Locate the factory wiring harness and antenna connector in the dash
and complete all necessary connections to the radio and climate
controls. Metra recommends using the proper mating adapter from
Metra or AXXESS. Test the radio for proper operation.
5. Secure the completed assembly into the dash using screws removed in
disassembly.
6. Snap the radio trim panel over the completed assembly, and then
reassemble the dash in reverse order of disassembly. (Figure B)
Metra. The World's Best Kits.
®

KIT ASSEMBLY

(Figure A)
(Figure B)
MetraOnline.com
I N S TA L L AT I O N I N S T R U C T I O N S
IMPORTANT
If you are having difficulties with the installation of this product,
please call our Tech Support line at 1-800-253-TECH. Before
doing so, look over the instructions a second time, and make
sure the installation was performed exactly as the instructions
are stated. Please have the vehicle apart and ready to perform
troubleshooting steps before calling.
© COPYRIGHT 2018 METRA ELECTRONICS CORPORATION
99-7345B
K P
®
NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
REV. 5/15/18 INST99-7345B