Kit Preparation; Kit Assembly - Metra 99-7629S Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Kit Preparation

To the 99-7629S radio trim panel:
1. Attach the factory climate controls using
(4) #8 X 3/8" Phillips screws supplied.
(Figure A)
2. Snap the outer trim rings onto the climate
control knobs. (Figure B)
3. Attach the passenger air bag light
assembly using (2) #8 X 3/8" Phillips
screws supplied. (Figure C)
Note: Apply the small round airbag sticker
previously removed to the air bag button.
4. Snap in the hazard light switch. (Figure D)
5. Attach (6) panel clips using the factory
radio panel as a reference for clip
positioning.
6. For models without rear A/C, snap in the
(2) rear A/C delete plugs.
Continued to kit assembly
0
1
2
3
4
(Figure A)
99-7629S
0
1
2
3
4
(Figure B)
0
1
2
3
4
(Figure C)
0
1
2
3
4
(Figure D)

Kit Assembly

ISO DIN radio provision with pocket
1. Secure the radio brackets to the
pocket using (4) #8 x 3/8" Phillips
screws supplied. (Figure A)
2. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
3. Slide the radio in the pocket/
bracket assembly, and then secure
to the assembly using the screws
provided with the radio. (Figure B)
4. Locate the factory wiring harness
and antenna connector in the
dash, and complete all necessary
connections to the radio. Metra
recommends using the proper
mating adapter from Metra and/or
AXXESS. Re-connect the negative
battery terminal and test the radio
for proper operation.
5. Reassemble the dash in reverse
order of disassembly, using the
99-7629S radio trim panel.
3
(Figure A)
(Figure B)

Publicidad

Tabla de contenido
loading

Tabla de contenido