Technical Data - Hilti PR 3-HVSG Manual De Instrucciones

1 PRA 2 remote control unit
1 PRA 54 target plate
2 Batteries (size AA cells)
1 Manufacturer's certificates
NOTE
en Accessories are available from your Hilti Center or can be ordered online at www.hilti.com.
3.13 Additional items required for operating the tool
The suitable, recommended B12/2.6 Li‑Ion battery and the C 4⁄12‑50 charger. For further information about battery
charging, please read the operating instructions for the battery charger.
3.14 Operating status indicators
The tool is equipped with the following operating status indicators: auto-leveling LED, inclination angle LED and shock
warning LED.
3.15 LED indicators
All LEDs
Auto-leveling LED (green)
Shock warning LED (orange)
Slope LED (orange)
3.16 Lithium‑ion battery charge status
The Li-ion battery features a charge status display. The charge status is indicated by the LEDs on the battery during
charging (please refer to the operating instructions for the charger). When the battery is not in use, its charge status
can be indicated by pressing the release button on the battery.
LEDs light constantly
LED 1, 2, 3, 4
LED 1, 2, 3
LED 1, 2
LED 1
-
NOTE
When the tool is in operation, the battery charge status is indicated in the display on the tool. If the battery charge
status LEDs blink, please refer to the information given in the "Troubleshooting" section.

4 Technical data

Right of technical changes reserved.
16
All manuals and user guides at all-guides.com
All LEDs blink
The green LED blinks.
The green LED lights con-
stantly.
The orange LED lights con-
stantly.
The orange LED lights con-
stantly.
LEDs blink
-
-
-
-
LED 1
The tool has been bumped, knocked off
level or is subject to some other error.
The tool is in the leveling phase.
The tool has leveled itself / is operating
normally.
Shock warning mode is deactivated.
Slope mode is active.
Charge status C
C ≧ 75 %
50 % ≦ C < 75 %
25 % ≦ C < 50 %
10 % ≦ C < 25 %
C < 10 %