Safety Instructions; General Safety Rules; Electromagnetic Compatibility; Before Use - Hilti PT 10 Manual De Instrucciones

Weight
Dimensions

5 Safety instructions

WARNING! Read all safety instructions and other in-
en
structions. Failure to observe the safety precautions and
instructions may result in electric shock, fire and/or seri-
ous injury. Keep all safety precautions and instructions
for future reference.

5.1 General safety rules

a) Check the condition of the tool before use. If the
tool is found to be damaged, have it repaired at a
Hilti service center.
b) The tool must be checked at a Hilti service center
after it has been dropped or subjected to other
mechanical stresses.
c) The tool is intended exclusively for indoor use.
d) Before operating the tool, check that it is com-
plete and standing or secured in a stable position.
e) The tool and its ancillary equipment may present
hazards when used incorrectly by untrained per-
sonnel or when used not as directed.
f) Have the tool repaired only at a Hilti service cen-
ter.
g) To avoid the risk of injury, use only genuine Hilti
accessories and additional equipment.
h) Modification of the tool is not permissible.
i) Observe the information printed in the operat-
ing instructions concerning operation, care and
maintenance.

6 Before use

6.1 Setting up the tool 3
1. Check that the surface of the table or bench is flat
and that it stands level.
2. Place the concrete base on a sturdy table or bench
(if the PTA 30 is used, assemble and secure this
table first).
NOTE Version without PTA 30 table: Use an open-
end wrench to adjust the screw feet so that the
bubble of the bubble level on the tripod adapter is
inside the inner ring. Tighten all lock nuts on the
screw feet securely.
14
36.4 kg
600 mm X 190 mm X 520 mm
j) Do not render safety devices ineffective and do
not remove information and warning notices.
k) Keep laser tools out of reach of children.
l) Take the influences of the surrounding area into
account. Do not use the tool where there is a risk
of fire or explosion.
m) Only laser tools featuring a visible laser beam may
be checked using the PT 10 quick check device.
5.2 Proper organization of the work area
a) Secure the working area and take care to ensure that
the surface of the bench or table is steady and level
when setting up the tool.
b) Ensure that the tool is set up on a steady, level
surface (not subject to vibration).
c) Do not set up the tool at a passageway or where
people frequently pass by (risk of tripping/falling and
injury).
d) Use the tool only within its specified limits.

5.3 Electromagnetic compatibility

Although the tool complies with the strict requirements
of the applicable directives, Hilti cannot entirely rule out
the possibility of the tool being subject to interference
caused by powerful electromagnetic radiation, leading
to incorrect operation. Check the accuracy of the tool
by taking measurements by other means when working
under such conditions or if you are unsure. Likewise, Hilti
cannot rule out the possibility of interference with other
devices (e.g. aircraft navigation equipment).
3. Position the flat surface of the concrete base so that
the hole for the tripod column lies beyond the edge
of the table.
NOTE Please observe the safety rules in the section
"Proper organization of the work area".
6.1.1 Fitting the tripod column 4 5 6
1. Fit the tripod column through the hole in the concrete
base from below and secure it with the screws.
NOTE Please note that crank must be positioned
toward the front.
2. Fit the tripod head onto the tripod column.