GGP ITALY SPA H 60K Manual De Instrucciones página 26

PREPARING TO WORK / HOW TO START - USE – STOP THE ENGINE
IMPORTANT
Periodically clean the petrol
and fuel mix containers to remove any eventual
deposits.
REFUELLING
DANGER!
!
Never smoke whilst refu-
elling and avoid inhaling the petrol fumes.
WARNING!
!
Carefully open the tank top
as pressure could have formed inside
Before refuelling:
– Shake the fuel mix container well.
– Place the machine on a flat stable surface,
with the fuel tank cap facing upwards.
5. HOW TO START - USE – STOP THE ENGINE
STARTING THE ENGINE
WARNING!
!
The engine must be start-
ed in an area at least 3 metres from where
you refilled the fuel tank.
Before starting the engine:
– Place the machine firmly on the ground.
– Remove the blade protection devices.
– Make sure the blade is not touching the
ground or any other object.
– Make sure the handgrip is locked in the centre
position (only HT 60K).
• Cold start
NOTE
A "cold" start of the engine
means starting it after at least 5 minutes from
when it was switched off or after refuelling.
– Clean the fuel tank cap and the surrounding
area to avoid any dirt from entering the tank
during refilling.
– Carefully open the fuel tank cap to allow the
pressure inside to decrease gradually. Use a
funnel to refill and avoid filling the tank to the
brim (Fig. 1).
WARNING!
!
Always close the fuel tank
cap firmly.
WARNING!
!
traces of fuel which may have dripped on the
machine or the ground and do not start the
engine until the petrol fumes have dissipated.
To start the engine (Fig. 2):
1. Press switch (1) to position "I".
2. Gently press the bulb (2) on the "primer" 7-10
times until the fuel flows from the exhaust
pipe.
3. Turn the starter control lever (3) to the
"START" position.
4. Hold the machine firmly on the ground with
one hand on the handgrip, in order not to lose
control of the machine during startup.
WARNING!
!
If the machine is not held
firmly, the force of the engine could cause the
user to lose his balance or direct the blade
towards an obstacle or the same user.
5. Slowly pull the handle (4) on the starter wire
10 - 15 cm, until you feel a certain amount of
resistance.
6. Then pull forcefully a couple of times to start
the engine.
IMPORTANT
To avoid breakages, never
pull the wire for its entire length and do not allow
it to rub against the wire guide outlet.
EN
Immediately clean
25
all