Using The Machine; Lubricating The Blades During Jobs; Cutting Procedures - GGP ITALY SPA H 60K Manual De Instrucciones

USING THE MACHINE

6. USING THE MACHINE
To respect persons and the environment :
– Please try not to cause any disturbance.
– Scrupolously comply with local regulations
and provision for disposal of waste materi-
als after trimming.
– Scrupolously comply with local regulations
and provision for the disposal of oils,
petrol, damaged parts or any element
which has a strong impact on the environ-
ment.
WARNING!
!
clothing when using the machine. Your retail-
er can provide you with all the information on
the most suitable accident prevention
devices to guarantee your safety at work
REGULATING THE HANDGRIP (Fig. 5) (only
HT 60K)
The rear handgrip (1) can be adjusted to 5 differ-
ent positions in relation to the cutting device to
make trimming your hedges easier.
WARNING!
!
The handgrip must only be
adjusted when the engine is switched off.
– Pull the release lever (2).
– Rotate the rear handgrip (1) to the desired
position.
– Before using the machine check that the
release lever (2) is correctly in place, and the
rear handgrip is firmly attached.
WARNING!
!
handgrip must always be in a vertical posi-
tion, whatever the position of the cutting
device (3).

CUTTING PROCEDURES

WARNING!
!
When cutting, always hold
the machine firmly with both hands.
WARNING!
!
Always wearing suitable
When working, the rear
Immediately stop
engine if the blades block while running or if
they get caught up in the hedge branches
It is recommended to trim the two vertical sides
of the hedge before trimming the top.
• Vertical trimming (Fig. 6)
Il taglio deve essere eseguito con un movimento
ad arco dal basso verso l'alto, tenendo la lama il
più distante possibile dal corpo.
• Horizontal trimming (Fig. 7)
The best results will be obtained with the blade
slightly inclined (5° - 10°) in the direction you are
cutting, proceed with a curved movement, slow-
ly and without interruptions, especially in the
case of very thick hedges.

LUBRICATING THE BLADES DURING JOBS

If the trimming device overheats whilst working,
it is necessary to lubricate the internal surfaces
of the blades..
WARNING!
!
be performed when the blades have stopped
running and the engine is switched off.
END OF OPERATIONS
When you have finished your work:
– Switch off the engine as indicated above
(Chap. 5).
– Wait for the blades to stop and replace the
protection device.
the
EN
This operation must only
27