SATA SATAminijet 3000 B HVLP Instrucciones De Servicio página 79

Operating instructions SATAminijet 3000 B HVLP / BT HVLP
5. Changing the Self-adjusting Seals
a) Material side: For replacing the self-adjusting paint needle packing,
paint needle and fluid tip must be removed first. After loosening the
packing screw, pos. 79905, with a screw driver, the fluid tip screw
can be removed. Insert new packing screw with screw driver from the
front side and tighten it thoroughly. Test fluid tip and paint nozzle for
damages and remount it.
b) Air side: Replace the air piston and the air piston packing. Remove
air micrometer and unscrew headless pin (64972). Push back air
piston by means of the trigger. Remove air piston. Remove stuffing
box screw and old packing and insert new packing (pos. 126292).
After this screw in stuffing box slightly against the block. Grease air
piston rod very slightly with spray gun grease (pos. 10009) and install
it. Mount trigger, air micrometer and fluid tip.
6. Cleaning and Maintenance
Never use force. Using improper tools such as pipe wrench, gas torch, etc. will void any
warranty. In many cases proper repairs can only be carried out with the aid of special tools.
In such cases, limit yourself to establishing the cause of the problem and leave the repairs
to the service department. We refuse to accept liability for perfect functioning of the spray
gun if it is disassembled by the customer.
a) Flush out the gun thoroughly with thinner or cleaning fluid.
b) Clean the air nozzle with a paint brush or brush. Do not immerse the nozzle in
thinner or cleaning fluid.
c) Under no circumstances try to clean clogged drillings using an unsuitable tool,
since the slightest amount of damage adversely affects the spray pattern. Use
SATA nozzle cleaning needles ((included in cleaning kit 64030).
d) Only remove the black air distribution ring (Order No. 127399 / set of 3) in the gun
head in case it is damaged (no sealing performance at the paint nozzle). In case
of removal, always insert a new air distribution ring to ensure flawless function.
Insert new air distribution ring in its correct position and tighten paint nozzle again.
Respect mounting instructions for the air distribution ring (see 6.1)!
d) Slightly oil movable parts with SATA special grease (order no. 10009).
Important Notice:
Gun may be cleaned with solvent or cleaning agents manually or in a conventional gun
washing machine.
The following actions damage the gun/system, may lead to the loss of the
explosion-proofness approval and entirely annull any warranty claims:
- Immersing the gun in solvent or cleaning agents, or for a period longer than required
for the cleaning process as such
- Storing the gun inside the gun washing machine
- Cleaning the gun by means of ultrasound cleaning systems
All manuals and user guides at all-guides.com
IX.5