Sony UPX-C200 Manual De Instrucciones página 13

3
Install the button battery CR-2025 in its case, and
insert the case.
C R 2 0
2 5
4
Insert four NH-AA batteries.
5
Close the lid and lock it by sliding the button to
CLOSE while pushing the lid.
Be sure to lock the lid securely.
Note on replacing batteries
When replacing batteries, they may drop down if the
battery compartment lid faces down. To avoid this, turn
the grip so that the lid faces up.
Role of the button battery
The button battery supplies power to the built-in clock.
Be sure to insert the battery.
The service life of the lithium button battery for the
built-in clock is normally about two or three years, but it
depends on the operating conditions. When the battery's
service life ends, the clock setting returns to midnight,
January 1, 2003. Once you see the time and date reset
like this, replace the battery with a new one. When
power is supplied to the camera, advance of the time and
date begins from this point.
You can check the time and date of a picture in Play
mode or on the properties display.
Connecting the camera to a wall outlet
Connect the DC cord of the PCS-AC08/1 AC power
adaptor (supplied) to the DC IN 8.4V jack of the camera.
Then connect the AC power adaptor to a wall outlet.
Now you can use the camera on AC power. Using an AC
power adaptor, you need not worry about the remaining
battery power.
VI DE O
Camera
PCS-AC08/1
AC power adaptor
(supplied)
Notes
• Use the AC power adaptor near the wall outlet. If some
trouble occurs during operation, immediately
disconnect the AC power adaptor from the wall outlet
to cut power supply.
FL AS H
LE AS E
O UT RE
DC IN 8.4V
8. 4V
DC IN
to wall outlet
AC power cord
(supplied)
Preparations
13