Grundfos MP 204 Instrucciones De Instalación Y Funcionamiento página 18

9.2.4 Number of phases
Set the number of phases with the
(functional earth)).
• Press to store the setting and continue.
R
• Press to store the setting and finish.
The programming mode ends automatically after 10 seconds, and the change is stored. See fig. 16.
Fig. 16 Example of basic setting
18
and buttons (1 phase, 3 phases (non-earthed) or 3 phases with FE
Status display
+
Press and hold for
approximately 5 seconds
Set rated current
10 seconds
The value is not stored
Set nominal voltage
10 seconds
The value is stored
Set trip class
10 seconds
The value is stored
Set number of phases
10 seconds
The value is stored
R
The value is not stored
R
The value is stored
R
The value is stored
R
The value is stored