All manuals and user guides at all-guides.com
Installation
7.2
Securing the generator
Note on installation location
Make sure that no combustible objects are stored or installed near the air
outlet or the ventilation slots. A distance of at least 50 cm should be kept.
For safety reasons, note the location of existing wiring harnesses, wires
and other components within the installation area, in particular those
which are not visible, when installing the generator (when drilling or
screwing etc.).
You can secure the generator with the mounting brackets supplied in two
ways:
External installation (fig. 5, page 5):
External installation has the following benefits: lower space requirement,
fast installation, easy access for maintenance work.
– To ensure the generator is attached securely, use the mounting
bracket (fig. 5 1, page 5) supplied.
– If the air intake opening of the generator is located behind a vehicle
wheel, you need to prevent the wheel from splashing any water into
the generator interior when it rains (e.g. by using a splash guard).
Internal installation (fig. 6, page 6):
For internal installation, using accesory kit AG 14087 (comprising two
mounting brackets 14087 and one seal AG 128), you need to prepare a
sealed compartment against the vehicle interior which can also be insu-
lated against sound.
– Remove external (high) mounting brackets supplied with the ePowerT.
Using the vibration dampers, nuts and screws supplied with the
ePowerT, assemble the internal (low) mounting brackets 14087.
– Attach exhaust and air intake openings to the floor and in front of the
generator cover. The air intake opening must have a cross-section of
at least 240 cm
– You must also fit a seal made of fire-retardant rubber (AG128) with a
thickness of at least 5 mm between the floor of the vehicle and the
generator (B und C).
Leave a space of at least 20 mm between the generator hood and
surrounding parts so that sufficient space remains for cooling air to pass
through.
30
2
(A).
ePower T, ePower T LPG
EN