Storing Stations In Memory; Fm Station Automatic Preset: Ssm; When An Fm Stereo Broadcast Is Hard To Receive - JVC KS-F190 Manual De Instrucciones

3
Tune in to a station you want while "M"
is flashing.
To tune in to stations of
higher frequencies
To tune in to stations of
lower frequencies
• If you release your finger from the button,
the manual mode will automatically turn off
after 5 seconds.
• If you hold down the button, the frequency
keeps changing (in 200 kHz intervals for
FM and 10 kHz for AM) until you release
the button.
When an FM stereo broadcast is hard
to receive:
Press MO (Monaural) while listening to an
FM stereo broadcast.
• Each time you press the button, the MO
indicator lights up and goes off alternately.
Lights up when receiving an
FM broadcast in stereo.
When the MO indicator is lit on the display,
the sound you hear becomes monaural but
the reception will be improved.
To restore the stereo effect, press the same
button again.
All manuals and user guides at all-guides.com

Storing stations in memory

You can use one of the following two methods to
store broadcasting stations in memory.
• Automatic preset of FM stations: SSM (Strong-
• Manual preset of both FM and AM stations

FM station automatic preset: SSM

You can preset 6 local FM stations in each FM band
(FM1, FM2 and FM3).
1
2
Local FM stations with the strongest signals
are searched and stored automatically in the
band number you have selected (FM1, FM2 or
FM3). These stations are preset in the number
buttons — No.1 (lowest frequency) to No.6 (highest
frequency).
When automatic preset is over, the station stored
in button number 1 will be automatically tuned into.
station Sequential Memory)
Select the FM band (FM1 – 3) you
want to store FM stations into.
Each time you press the button, the FM
band changes as follows:
FM1
FM3
Press and hold both buttons for
more than 2 seconds.
"SSM" appears, then disappears when automatic
preset is over.
FM2
7