Stanley Bostitch GFN1564K Manual De Instrucciones página 11

Table 1: Recharging time (approx. mins) at 20°C
Battery Battery Capacity (Ah)
voltage (V)
3.6V 9B12070R-EU
NOTE: The recharging time may vary according to the
ambient temperature.
4. Disconnect battery charger from the receptacle or
cigarette lighter socket
5. Hold the charger firmly and pull out the battery
NOTE: Do not store the battery in the charger once fully
charged.
Note: electric discharge in case of new batteries
The internal chemicals of new batteries and batteries
that have not been used for an extended period may not
activated and the electric discharge might be low when
using them for the first few times. This is a temporary
phenomenon, and normal recharging time will be
restored by recharging the batteries 2 or 3 times.
How to make the batteries perform longer.
(1) Recharge the batteries before they become
completely exhausted.
When you feel that the power of the tool is becoming
weaker, stop using the tool and recharge its battery. If
you continue to use the tool and exhaust the electric
current, the battery may be damaged and its life will
become shorter.
(2) Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately after use.
If such a battery is recharged immediately, its chemicals
will deteriorate, and the battery life will be shortened.
Leave the battery and recharge it after it has cooled.
PREPARING TO USE THE TOOL
Make sure you have read and understood all the
warnings listed in this manual before proceeding to use
the tool
● When fitting fuel or batteries to the tool, the fastener
discharge area of the tool should be pointed away
from the operator and others in the working area.
Place the discharge area of the tool over a test
piece of material of sufficient thickness to fully
accommodate the dimensions of the fastener to be
driven. With hands clear of the trigger and trip
mechanism and with limbs and body clear of the
discharge area, the fuel cell and battery may now
be connected.
All manuals and user guides at all-guides.com
● Do not pull the trigger or depress the safety trip
1.5 Ah
SAFETY INSTRUCTIONS FOR
60 mins.
LOADING THE TOOL
When loading the tool:
1. Never place a hand or any part of the body in fastener
discharge area of the tool;
2. Never point the tool at self or anyone else.
3. Do not pull the trigger or depress the safety trip as
accidental actuation may occur, possibly causing injury.
Note: See the technical specifications in the front of this
manual for specific loading instructions and dimensions
of recommended fasteners.
SAFETY INSTRUCTIONS FOR TOOL
OPERATION
Always handle the tool with care:
● Never engage in horseplay;
● Never pull the trigger unless the nose is directed
● Keep others at a safe distance from the tool while
● The operator must not hold the trigger pulled on
● Keep hands and body away from the discharge area
● Check operation of the safety trip mechanism
● Do not drive fasteners on top of other fasteners as
● Do not drive fasteners close to the edge of the work
while connecting the fuel cell and battery. The tool
could cycle, possibly causing injury.
towards the work.
the tool is in operation, as accidental actuation may
occur, possibly causing injury.
safety trip tools except during fastening operation,
as serious injury could result if the trip accidentally
contacts someone or something, causing the tool to
cycle.
of the tool. A safety trip tool may bounce from the
recoil of driving a fastener and an unwanted second
fastener may be driven possibly causing injury.
frequently. Do not use the tool if the contact arm is
not working correctly, as accidental driving of a
fastener may result. Do not interfere with the proper
operation of the safety trip mechanism.
this may cause deflection of the fastener, which
could cause injury.
piece as the wood may split allowing the fastener
to be deflected, possibly causing injury.