Charging The Battery - Stanley Bostitch GFN1564K Manual De Instrucciones

TRANSPORTATION
● Shipment via mail is not allowed.
● Transportation of small quantities for own use in a
private car is allowed without shipping papers and
emergency card.
● Observe temperature limit of 50°C (120°F).
STORAGE
● Do not store in passages, entry halls, near doors and
exits or in attics.
● Ensure the tool, gas cell and battery are all stored in
accordance with local Fire Safety Regulations
● Observe local regulations about storage, handling
and transportation of aerosol products and
according to TRG300(D). International regulations
are established according to ADR/RID; IATA-DGR;
IMDG-Code
● Fuel Cell transportation & storage. According to
GGVS-ADR, no special licence is required for the
transportation of fuel cells.
Road/Rail: see GGVS-ADR/RID CI.2/ITEM 10B2
Seafreight: see IMDG CI.9/P.9022/EmS No. 2-13
Air/IATA-DGR: see CI.2/Risk Gr.3/Packinstr. 203 / max
weight per shipment 75kg / cargo 150 kg
Note: Goods must be accompanied by transport
emergency card for road UN No. 1950 (Emergency
CI.2 GGVS/ADR, Rn.. No. 2201, Item IB02)
Transportation of small quantities for own use in a
private car is allowed without shipping papers and
emergency card.
● Sales booths should not be close to exits.
● A fire extinguisher of 6 kg, class A, B, or C must be
available.
● Packages should be stacked up in a safe manner,
so that they don't fall to the ground.
● Store rooms must not take more than 20 m2 of room
surface.
● Do not store together with pyrotechnical goods.
● The quantity stored in sales rooms should not
exceed daily sales.
● Tools with an open flame or high temperature must
not be operated near fuel cells.
● Fuel cells must not be displayed in shop windows.
All manuals and user guides at all-guides.com

CHARGING THE BATTERY

Before using the power tool, charge the battery as
follows:
1. Insert the charger connecting plug into the connecting
socket of the charger (Fig. 1b)
2. Connect to a power source as follows:
If using the AC adapter:
-Plug the AC adapter into the power outlet.
If using the cigarette lighter connecting plug:
i. Secure the battery charger in place in the car, using
the strap supplied to fasten the charger in place and
prevent it from moving inadvertently. (Fig. 2)
ii. Insert the cigarette lighter connecting plug into the
cigarette lighter socket. If the plug is loose and falls out
of the cigarette lighter socket, the socket may be faulty
and you are recommended to contact your local car
dealer.
Note: continued use of the socket may result in an
accident due to overheating.
CAUTION: Do not place the battery charger or battery
under the driver's seat. Secure the battery charger in
place to prevent it from moving inadvertently as this may
lead to an accident. (Fig. 2)
CAUTION: Do not use the electrical cord if damaged.
Have it repaired immediately.
3. Insert the battery in the charger
Position the battery so that the nameplate faces toward
the nameplate of the charger and press in the battery
until it comes into contact with the bottom plate (Fig. 1b).
Inserting the battery will turn on the charger and the
indicator light will turn on.
CAUTION: If the indicator light does not come on, pull
out the power cord from the receptacle and check the
battery mounting condition.
The indicator light goes off to show that the battery is
fully charged.
CAUTION: If the battery is heated just after operation (for
example due to direct sunlight), the charger indicator
light may not come on. If this occurs, allow the battery to
cool first and then start charging.
Recharging time: Table 1 shows the recharging time
required according to the type of battery.