Additional Tires - Rapid UNIVERSO 1500 Manual De Instrucciones

6.4

Additional tires

EN
154
Additional tires increase the suitability for slopes.
Mounting
• Replace all the wheel nuts with 3 x special wheel nuts (1).
• Mount the locknut (2) and locking plate (3).
• Remove the cap from the wheel axle, mount the bolt (A) and tighten it.
Two tires:
• Mount the wheel or cage wheel on the driver flange (4) using wheel bolts (9).
• Engage the hook (8) in the bore of the locking plate (3).
• Center the driver flange (4) onto the wheel nuts (1+2) and connect the traction shaft (5)
with the bolt (A); then tighten the driver flange on the wheel by means of the mandrel (6).
• Remove the mandrel (6) and secure the traction shaft (5) with a spring clip (7).
Three tires:
• Mount the wheel to the driver flange (10) using special wheel bolts (14) and tighten
them.
• Mount the safety screw (15) and locking plate (16) to the driver flange (10).
• Engage the hook (13) in the bore of the locking plate (3).
• Center the driver flange (10) onto the wheel nuts (1+2) and connect the traction shaft
(11) with the bolt (A); then tighten the driver flange on the wheel by means of the key
(12).
• Insert the key (12) and secure it using the spring clip (17).
• Mount the wheel or cage wheel on the driver flange (18) using wheel bolts (23).
• Engage the hook (22) in the bore of the locking plate (16).
• Center the driver flange (18) onto the wheel nuts (1+2) and connect the traction shaft
(19) with the traction shaft (11), then tighten the driver flange on the wheel by means of
the mandrel (20).
• Remove the mandrel (20) and secure the traction shaft (19) with a spring clip (21).
Machine no. from CH 1001