Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5.5
Coupling and uncoupling attachment units
EN
5.6
Steering the machine
150
Coupling
•
Clean the connecting piece of the machine and of the attachment unit.
•
Grease the teeth of the PTO shaft and the connecting piece.
•
Open the attachment unit lock.
•
Push the attachment unit into the machine connecting piece.
•
Close the attachment unit lock.
•
Move the attachment unit or the machine until the attachment unit lock engages.
Uncoupling
•
Secure the machine against rolling away again.
•
Open the attachment unit lock and uncouple the attachment unit.
•
Close the attachment unit lock.
The machine may suddenly trap the operator or third persons, cause them to fall over or
run them over.
•
During coupling and uncoupling, ensure that nobody is in the danger zone.
•
Attachment may only be connected to machine if engine is switched off.
•
Coupling and uncoupling may cause hand injuries; wear safety gloves.
•
After coupling attachments, check whether the attachment locking bolt is engaged and
the attachment is connected to the machine.
Bolt engaged
When actuating the left lever, the machine turns towards the left. When actuating the right
lever, the machine turns towards the right. The stronger you actuate the lever, the narrower
becomes the curve radius.
Actuating the levers simultaneously will decelerate the travel drive.
•
The machine can suddenly trap the user or third persons, cause them to fall over or run
them over.
Warning
Bolt not engaged
Note
Warning
Machine no. from CH 1001
Publicidad
Capítulos
Tabla de contenido
