Spot Light; Illumination; Counterbalance System; Mounting Flange - Adapter - Rapid UNIVERSO 1500 Manual De Instrucciones

6.6

Spot light

6.7

Illumination

6.8

Counterbalance system

EN
6.9

Mounting flange - adapter

156
The spot light allows a good illumination of the working area.
Thanks to a flexible fastening, the spot light can be adjusted laterally and its height can be
adapted so that the working area is optimally illuminated.
The lighting on the left and on the right of the handlebar can be used as low-beam light
when working in road traffic or as general illumination of the working area.
Please observe the national regulations for working in road traffic.
The counterbalance system makes it possible for the heavy attachment to be in a horizontal
position in the raised condition.
1
3
The attachment units of the manufacturers AGRIA or Vogel & Noot can be mounted onto
the machine using a mounting flange (adapter) of the same manufacturers.
Insert the mounting flange into the connecting piece of the machine and secure it with the
device locking. Then the attachment unit of the above mentioned manufacturer can be
mounted.
Note
Default setting:
• Couple attachment to drive machine.
• Move attachment to horizontal position.
• Close lever (1) at counterbalance system
until the finger (2) is touching the
counterface of the attachment and
encounters resistance.
• Slacken lever (1) by two turns.
2
• Swivel down lever (1) to provided notch (3),
spring is pretensioned to the correct value.
Machine no. from CH 1001