Weight Carrier - Rapid UNIVERSO 1500 Manual De Instrucciones

The layout of the additional tires and the driver flange can be changed.
If you use additional tires or a cage wheel, the wheel locking must be mounted.
Maximum two tires are permitted on one side. For a 5x10 tire or a wheel diameter of up to
530 mm, three tires are allowed.
The machine can suddenly trap the user or third persons, cause them to fall over or run
them over.
6.5

Weight carrier

The weights on the weight carrier are used for balancing the machine optimally and
increase the traction of the wheels.
Heavy attachment units increase the lifting force on the handlebar. Stacked weights on the
weight carrier can reduce the lifting force.
In case of 5 weights (1), they are directly mounted to the weight carrier (2) and clamped with
the star grip (3). In this case, the retaining spring (4) is not required and can be stored in the
tool box.
In case of less than 5 weights (1), either the position of the weight carrier plate (5) can be
changed so that the weights are placed directly onto the weight carrier, or the retaining
spring (4) is used as support for the weights. Then the weights are in top position. The
weights are clamped with the star grip (3).
Maximum 5 stacked weights each of 8.5 kg are permitted on the weight carrier.
Machine no. from CH 1001
Securing the additional tires
• Mount the safety rope (2) with the bolt
(6) to the driver flange (1).
• Engage the hook (3) in the eye of the
safety rope.
• Fasten the safety plate (4) with the
special locknut (5a) or safety screw
(5b) to the wheel or driver flange (not
in the figure).
• Engage the hook (3) in the bore of the
safety plate (4).
Note
Warning
Note
EN
155