Viking MF 440 Guia De Instalacion página 7

Ocultar thumbs Ver también para MF 440:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
connected.
SEAT SWITCH (MF 480)
A switch must be installed on the underside of the
seat. This plays an important role in the machine's
safety system.
On delivery, the switch is suspended from both its
cables in the seat bracket. To facilitate installation,
disconnect the switch from the cables.
Then install the switch on the underside of the seat
using the screws C (fig. 5).
Connect the switch to the cables again. The cables
can be connected to any pin. Install the seat as
shown below.
SEAT
Install the seat on the seat bracket (fig. 6).
In the rear holes, the screws H should be used
along with the shoulder washers G and two wash-
ers J. Tighten the screws.
Then place the knobs I with two washers J in the
front holes.
The seat can be moved backwards or forwards.
Place the seat in the desired position and then tight-
en the knobs properly.
The seat can be folded. If the machine is parked
outside when it is raining, fold the seat forward to
protect the seat cushion from getting wet.
The seat is locked in the folded forward position.
To fold the seat down, first lift up the catch S
(fig. 6).
STEERING WHEEL
In order to compensate for any axial play, the shim
washers E and/or F should be used.
First check whether and if so how many shim
washers are required.
Then install the steering wheel by knocking in the
tension pin D (fig. 7).
The steering wheel should be installed so that the
steering wheel boss is in the "10 o'clock position".
TOWING HITCH
Screw the drawing plate K into the two holes on
the underside of the bumper using screws L and
nuts M (fig 8). Tighten the screws properly.
All manuals and user guides at all-guides.com
ENGLISH
TYRE PRESSURE
Check the air pressure in the tyres. Correct air
pressure:
Front: 0.4 bar (6 psi)
Rear: 1.2 bar (17 psi)
ACCESSORIES
For the installation of accessories, see separate in-
stallation guide supplied with each accessory.
Note: The cutting deck is regarded as an accessory
here.
EN
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mf 460Mf 480

Tabla de contenido