Assembly Components; Grip Assembly - Stiga BC 625 Serie Manual De Instrucciones

D. Cutting means: the element designed to cut
vegetation
1. Cutting line head: nylon line cutting
means.
2. 3 point, 4 point and 8 point blades:
metal disk cutting means.
3. Saw blade (if allowed): circular
metal disk cutting means with
peripheral cutting teeth.
E. Cutting means guard: it is a safety device
which prevents objects drawn up by the
cutting means from being hurled away from
the machine.
1. Cutting line head
2. Saw blade (if allowed)
Front hand grip: semi-circular shaped,
F.
it is used to handle the machine and
is equipped with a leg guard.
G. Rear hand grip: used to handle the
machine and equipped with the main
on/off/acceleration control buttons.
H. Leg guard: a safety guard that
prevents accidental contact with
the cutting means during use.
Handle bar: "ox horn" shaped handle
I.
bar transversely placed to the rod and
asymmetrically to it; used to control
the machine and equipped, on the
right hand side, with the main on/
off/acceleration control buttons.
J. Display: information regarding
the machine operation and
maintenance is displayed.
K. Connection point (of the harness): where
the harness is connected to the machine.
L. Harness: device made up of a fabric belt
which, placed over the shoulders, helps to
support the weight of the machine during
work.
1. single strap
2. double strap
3. with backpack
M. Blade protection (for machine transport and
handling): protects against accidental contact
with the cutting means that can cause serious
injuries.
4. ASSEMBLY
IMPORTANT The safety regulations to follow
are described in chap. 2. Strictly comply with these
instructions to avoid serious risks or hazards.
For storage and transport purposes, some
components of the machine are not installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the assembly
should be done on a flat and stable surface,
with enough space for machine handling and
its packaging,
equipment. Do not use the machine until all
the indications provided in the "ASSEMBLY"
section have been carried out.

4.1 ASSEMBLY COMPONENTS

The packaging includes assembly components.
4.1.1 Unpacking
1. Carefully open the packaging, paying attention
not to lose components
2. Consult the documentation in the box,
including these instructions.
3. Remove all the unassembled parts from the box.
4. Slide the trimmer-cutter out of the box.
5. Dispose of the box and packaging in
compliance with local regulations.

4.2 GRIP ASSEMBLY

4.2.1 Fitting the front hand grip - Type I
1. Position the cap (Fig. 3.A) by inserting
the pin (Fig. 3.A.1) into one of the holes
available on the transmission tube.
2. Fit the front grip complete with leg
guard barrier (Fig. 3.B) using the screws
(Fig. 3.C), taking care to keep the two anti-
vibration half-shells in place (Fig.3.D).
3. Fully tighten the screws (Fig. 3.C).
4.2.2 Fitting the front hand grip - Type II
1. Position the cap (Fig. 4.A) by inserting
the pin (Fig. 4.A.1) into one of the holes
available on the transmission tube.
2. Fit the front hand grip (Fig. 4.B)
with the screws (Fig. 4.C).
3. Fully tighten the screws (Fig. 4.C).
EN - 6
always making use of suitable