Start Up; Preparing The Icemaker For Long Storage - Hoshizaki AM-20CAE Manual De Instrucciones

All parts are factory-adjusted. Improper adjustments may result in failure.
If the unit is turned off, wait for at least 3 minutes before restarting the icemaker to prevent
damage to the compressor.
This icemaker is designed to produce edible ice. To keep the icemaker hygienic:
* Wash your hands before removing ice. Use the plastic scoop provided (accessory).
* The storage bin is for ice use only. Do not store anything else in the bin nor use other
electrical appliances in the bin.
* Clean the storage bin before use (see "III. 1. CLEANING").
* Keep the scoop clean. Clean it by using a neutral cleaner and rinse thoroughly.
* Close the door after removing ice to prevent entrance of dirt, dust or insects into the storage
bin.

1. START UP

1) Plug in the icemaker.
2) Open the water supply tap.
3) Prime the water pump by adding 1 litre of water to the water tank.
4) Move the power switch to the "ON" position.
Ensure the tank is primed before ice production commences to assure good quality ice from the
first cycle.

2. PREPARING THE ICEMAKER FOR LONG STORAGE

This icemaker will not work at subfreezing temperatures. To prevent damage to the water
supply line, drain the icemaker when air temperature is below zero.
When shutting down the icemaker for two or more days, drain the icemaker to prevent
contamination in the water circuit.
1) Unplug the icemaker.
2) Close the water supply tap, and remove the inlet hose.
3) Remove all ice from the storage bin, and clean the bin.
4) Ask a professionally qualified person to drain the icemaker.
NOTICE
HYGIENE
IMPORTANT
NOTICE
HYGIENE
7
ENGLISH