Preparation For Installation - Agilent Technologies Turbo-V 250 Manual De Instrucciones

16 Instructions for Use

Preparation for Installation

Preparation for Installation

The controller is supplied in a special protective packing. If this
shows signs of damage which may have occurred during transport,
contact your local sales office. When unpacking the controller, ensure
that it is not dropped or subjected to any form of impact. Do not
dispose of the packing materials in an unauthorized manner. The
material is 100% recyclable and complies with EEC Directive 85/399.
Figure 1
The controller model 969-9504 is factory set for a power supply: of
120 Vac. If a change in line voltage operation is desired, proceed as
follows:
196/240
Controller Packing
Disconnect the power cord from the controller P17 connector.
Select the operating voltage on the left panel.
Check voltage selector for correct set and connect power cord to
P17 connector.
Turbo-V 250 Controller User Manual / 87-900-856-01 (E)