Publicidad
Idiomas disponibles
Idiomas disponibles
4. Plug the STD relay harness into
the "12V" & "SIGNAL" terminal
of the IC Relay 6.
NOTICE
Be sure of the position of the
harness as shown in picture.
Brown wire ---> "12V",
Purple wire ---> "SIGNAL"
5. Connect the Earth Wire 8 to
the "GND" terminal of the IC
Relay 6.
6. Install the IC Relay 6 into the
position where the STD relay
was installed.
7. Connect the Earth Wire 8 to (–
) terminal of the battery.
8. Clamp the battery (–) lead wire
and Earth Wire 8 at the tape
portion with the Clamp 9.
NOTE: Cut off the excess Clamp
9.
Brown "12V"
GENUINE SUZUKI ACCESSORIES
5/10
Purple "SIGNAL"
SIGNAL
Battery (−) lead wire
Publicidad
