Maintenance; Checking The Safety Devices - ANTEO MICROPLUS MP 075 C Uso Y Mantenimiento

MAINTENANCE

Checking the safety devices

ANTEO SERIES MICROPLUS ... tail lifts do not require any particularly complicated servicing procedures. These checks should be carried out in order to ensure the product reliability as for
the safety of operators and third parties. The time engaged in these simple operations will make the tail lift more reliable, thus prolonging its operational life.
Component
Footboard clearance lights
Safety valves (on cylinders)
Double-operation controls
Plates indicating the loads, the capacity
as well as the warnings
Green pilot light "POWER ON"
Should one of the above mentioned components be damaged, IMMEDIATELY apply to an ANTEO Authorized Service Center.
MAINTENANCE
Checking the safety devices
ANTEO SERIES MICROPLUS ... tail lifts do not require any particularly complicated servicing procedures. These checks should be carried out in order to ensure the product reliability as for
the safety of operators and third parties. The time engaged in these simple operations will make the tail lift more reliable, thus prolonging its operational life.
Component
Footboard clearance lights
Safety valves (on cylinders)
Double-operation controls
Plates indicating the loads, the capacity
as well as the warnings
Green pilot light "POWER ON"
Should one of the above mentioned components be damaged, IMMEDIATELY apply to an ANTEO Authorized Service Center.
check method
visual – if fitted, turn the key-operated switch (C3) to ON and make sure that they are flashing
functional – carry out any lowering operation or downward rotation, then make sure that once
the controls are released, an immediate movement stop occurs
by operating one selector only, a maneuver should be NEVER performed
visual check (they should be ALWAYS perfectly LEGIBLE and VISIBLE
from any control position)
check it turns on regularly with microswitch (C3) on position ON
check method
visual – if fitted, turn the key-operated switch (C3) to ON and make sure that they are flashing
functional – carry out any lowering operation or downward rotation, then make sure that once
the controls are released, an immediate movement stop occurs
by operating one selector only, a maneuver should be NEVER performed
visual check (they should be ALWAYS perfectly LEGIBLE and VISIBLE
from any control position)
check it turns on regularly with microswitch (C3) on position ON
E
E
frequency
during use
during use
during use
during use
during use
71
frequency
during use
during use
during use
during use
during use
71