Sensor Label Information - Siemens SITRANS FUT1010 IP65 NEMA 4X 7ME363 Inicio Rápido

NOTICE
Weather Seal Malfunctions
Incorrect installation of weather seals may result in failure to meet to IP65 standards and
damage to the equipment.
Install weather tight seals at all unused holes using proper cable conduit and close
additional holes to IP65 standards.
2.3

Sensor Label Information

Sensor Label Markings
All Sensors are supplied with a metallic nameplate attached directly to the surface of the
Sensor. The nameplate displays information regarding the operating limits of the Sensor as
well as dimensional and other information required to insure the proper application and
operation of the flowmeter. The information included in the Sensor nameplate is listed below:
● SIEMENS (Manufacturer of this flowmeter)
● METER BODY MODEL and SERIAL # (Code contains Sensor material, size and flange
● FLOWMETER P/N and SERIAL # (Indicates the specific transmitter electronics
● TRANSDUCER P/N (Indicates part number of the transducers installed in this Sensor)
● DOM (Date of Manufacture MM/DD/YY)
● METER SIZE / CL (Meter size with ANSI or DIN flange class rating)
● I.D. (Internal Diameter of Sensor)
● WEIGHT (Weight of Sensor indicated in either Lbs or Kg)
● MAT BODY/FLANGE (Material of Sensor and flanges)
● BODY DESIGN CODE (Design code to which Sensor is fabricated)
● FLANGE DESIGN CODE (Design code to which flowmeter flanges are fabricated)
● Qmin / Qmax (Minimum and maximum actual flow that can be measured within AGA8
● Min OP (minimum operating pressure required for accurate flow measurement)
● MAOP (maximum allowable operating pressure of Sensor)
● OP TEMP (Operating temperature range of Sensor, including transducers)
● STORAGE TEMP (Recommended storage temperature of Sensor)
● HYDROSTATIC TEST PRESSURE (DOT MM/DD/YY)
FUT1010 IP65 NEMA 4X & IP66 NEMA 7 Gas Quick Start
Operating Instructions, 1/2013, A5E02639183-AC
class)
configured for this Sensor)
accuracy guidelines)
Install/mounting
2.3 Sensor Label Information
15