Figure 2-3 Sensor Installation; Figure 2-4 Hazardous Location Sensor Installation - Siemens SITRANS FUT1010 IP65 NEMA 4X 7ME363 Inicio Rápido

①
②
Figure 2-3
Always use flange bolts and nuts (not supplied unless requested) that are appropriate for the
size and class of the Sensor flange. Flange Isolation kits (not supplied) should be utilized
when indicated by the facility.
The following figure illustrates the hazardous location installation of the Sensor. It is shown
connected to the upstream and downstream pipes with the optional flow conditioner installed
and connected to the customer's pipe.
①
Customer's Pipe
②
Flow Conditioner (Optional)
③
Upstream Pipe (Optional)
④
To Transmitter (See Note 1)
⑤
Junction Box (See Note 1)
Figure 2-4 Hazardous Location Sensor Installation
FUT1010 IP65 NEMA 4X & IP66 NEMA 7 Gas Quick Start
Operating Instructions, 1/2013, A5E02639183-AC
Lifting cable within 10° of vertical
Lifting Eye
Sensor Installation
2.4 Sensor Installation Procedure
③
④
⑥
Transducer Enclosure (2, 3 or 4 places. See Note 1)
⑦
Line Taps (2) (See Note 3)
⑧
Sensor (See Note 4)
⑨
Downstream Pipe (Optional)
⑩
Line Taps (2) (Refer to Note 3)
⑪
Customer's Pipe
Install/mounting
Horizontal Alignment
Sensor
19