Alarm Codes - Siemens SITRANS FUT1010 IP65 NEMA 4X 7ME363 Inicio Rápido

Troubleshooting

5.2 Alarm Codes

5.2 Alarm Codes
Alarm Codes and Descriptions
The following alarm codes appear on the main display of the flow meter.
Letter Codes
S SPACE
R HI/LO
F FAULT
T TURB
M MEMRY
K MAKUP
I
Z
The displays shown below indicate where the Alarm Codes appear on the screen. Press
<UP> or <DOWN> Arrows to change screen views.
①
42
Alarm Code
Spacing Sensor spacing may need adjustment
Rate Flow above High setting or below Low setting
Fault Three continuous seconds without new data update
Turbulence Current turbulence percentage exceeds the alarm set point
Memory Last valid reading for a selected interval during Fault condition
Makeup In-Process Makeup occurred
The following alarm codes appear in the Datalogger status messages:
Vs Interface Gas Vs exceeds Vs Interface set point
ZeroMatic ZeroMatic signal fault
Alarm Codes
Description
FUT1010 IP65 NEMA 4X & IP66 NEMA 7 Gas Quick Start
Operating Instructions, 1/2013, A5E02639183-AC