Before You Begin - WAGNER 4-Step Electronic Pro Duty Power Painter Manual Del Propietário

CONTROLS AND PARTS
Pump housing
Locking nut
Spring
Swirl valve (2)
Spray tip

BEFORE YOU BEGIN

NOTE: It is important to mix the material thoroughly
before you begin. Do not shake the material
to mix it. Always stir the material gently but
thoroughly before use.
NOTE: Remove any skin that has formed on the top
of the matierial. Do not mix the skin into the
material. The skin can break up and clog the
sprayer. Older paint may need to be strained.
ONE-QUART SETUP
1. Fill the container with the material to be used.
2. Place a few drops of household oil down the intake and
return openings in the pump housing.
Intake
opening
3. Insert the suction set into the intake opening and thread the
container securely to the sprayer.
4. Plug in the unit.
CAUTION
Never tip the sprayer at more than a 45° angle when using
the small container. Material could get into the motor
housing and damage the sprayer.
© 2001 Wagner Spray Tech. All rights reserved.
All manuals and user guides at all-guides.com
Power switch
Motor
housing
Spray
Piston
tip
Pump
housing
Fluid
container
Return
opening
Flow knob Suction extension
Suction
set
Handle
SUCTION EXTENSION SETUP (OPTIONAL)
1. Place a few drops of
household oil down
the intake (center)
and return (back)
openings in the
pump housing.
2. Push the dual hose
fitting into the intake
and return openings
on the bottom of the
housing. The fitting
with the ridge goes
into the return
opening.
3. Place the pump
housing locking collar
over the dual hose
fitting and turn the
locking collar clockwise
unil it locks securely.
4. Push the suction hose
set onto the intake and
return ports of the dual
hose fitting. The hose
with the writing on it
goes to the intake
(center) port.
5. Slide the intake hose
(the hose with the writing on it) through the container clip.
You may need to pull the hoses slightly apart.
6. Press the suction set hose
adapter onto the suction set.
7. Push the intake hose onto the
suction set assembly. Make
certain that the intake filter is
in place on the suction set.
8. Submerge the suction set
assembly into the material
container and attach the
container clip to the side to
hold it securely. Make certain
that the return line is inside the
container.
Return
Container
line
clip
Read PRIMING WITH SUCTION
EXTENSION instructions before
spraying.
3
Container
clip
Cleaning brush
Return
opening
Intake
opening
Dual hose
fitting
Ridge
Locking
collar
Intake
port
Intake
hose
Suction set
hose adapter
Suction set
Intake filter
English
Dual hose
fitting
Wide
angle
tip
Intake
hose
Container
clip