Product Registration Card - WAGNER 4-Step Electronic Pro Duty Power Painter Manual Del Propietário

REPLACING THE PISTON AND SPRING
The average life of a piston and spring will vary depending on
the types of material being sprayed.
NOTE: Replace the piston if the sprayer takes longer
than 15 seconds to prime when well
lubricated, or if there is an excess amount of
material leaking, refer to the troubleshooting
suggestions listed in this manual. Replace the
spring if you notice that it is broken when you
clean the sprayer.
1. Make certain the sprayer is unplugged.
2. Turn the spray tip counterclockwise until it is removed.
Be careful not to lose the swirl valve.
Spray tip
3. Pull out the swirl valve.
4. Turn the locking nut counterclockwise until it is removed.
Locking nut
5. Slide the pump housing assembly off of the sprayer.
6. Pull the piston and spring off of the pump housing.
7. Pull the spring off of the piston and throw away the old piston.
8. Slide the spring onto the front end of the new piston.
9. Insert the piston into the back end of the pump housing.
Pump housing
Locking nut
Spray tip
10. Insert the pump housing assembly into the front of the sprayer.
11. Place the locking nut onto the motor housing.
12. Press in while turning the locking nut clockwise and tighten
firmly by hand.
CAUTION
Do not cross-thread the locking nut. Make certain it is
threaded correctly before tightening. Make certain that the
pump housing is pushed far enough into the sprayer and
that the locking nut is screwed on tightly.
13. Insert the swirl valve into the front end of the pump housing.
14. Place the spray tip onto the pump housing and turn it
clockwise until it is tightened securely.
© 2001 Wagner Spray Tech. All rights reserved.
All manuals and user guides at all-guides.com
Pump
housing
opening
Swirl valve
Piston
Spring
Swirl
valve
ADDITIONAL REPAIRS
If you have any problems that are not solved by the
troubleshooting section of this manual, please call Wagner
Technical Service at 1-800-328-8251 Monday through Friday
between 8:00 AM and 4:30 PM Central time. An automated
Self-Help option is also available at 1-800-760-3844 and
www.wagnerspraytech.com, seven days a week, twenty-four
hours a day. If you suspect that you have a problem with the
electrical system, or have any other problems not solved by the
routine maintenance described in this manual, take your sprayer
to the nearest authorized service center.

PRODUCT REGISTRATION CARD

Send in your product registration card or register online at
www.wagnerspraytech.com. Proper registration will serve as
proof of purchase in the event your original receipt becomes
misplaced or lost. Returning this card will expedite the
processing of your warranty. Be sure you write your unit's date
code on the card before sending it. The date code is located at
the base of the handle (for example, T087R). The additional
information will also help us to develop new products that best
meet your needs and desires.
9
English