EN
Description
WARNING: DO NOT use a single trigger collet with a dual trigger rotary handpiece. Installing a single trigger
collet onto a dual trigger rotary handpiece creates a pinch point between the clamping lever and the forward
trigger of the handpiece.
Wire collet and pin collet attachments are used to install wire and pins. Select the appropriate collet based on the
handpiece type and the wire or pin diameter.
All collets have a pre-adjust knob with small (S), medium (M), and large (L) diameter settings. Set the pre-adjust
knob to the proper diameter range.
COLOR
MODEL REF
STRIPE
8203-026-000
Green
8203-036-000
8203-126-000
Orange
8203-136-000
8203-226-000
Blue
8203-236-000
6
DIMENSIONS
Length: 112.2 mm; Height:
155.4 mm; Diameter:
27.4 mm; Mass: 203.0 g
Length: 112.2 mm; Height:
155.4 mm; Diameter:
27.4 mm; Mass: 203.0 g
Length: 112.2 mm; Height:
155.4 mm; Diameter:
27.4 mm; Mass: 203.0 g
Length: 112.2 mm; Height:
155.4 mm; Diameter:
27.4 mm; Mass: 203.0 g
Length: 112.2 mm; Height:
155.4 mm; Diameter:
27.4 mm; Mass: 203.0 g
Length: 112.2 mm; Height:
155.4 mm; Diameter:
27.4 mm; Mass: 203.0 g
HANDPIECE
TYPE
Single and Dual
0.7 to
Trigger
1.4 mm
[0.028 to
0.055 inch]
Single Trigger
Single and Dual
2.0 to
Trigger
2.4 mm
[0.079 to
0.094 inch]
Single Trigger
Single and Dual
3.0 to
Trigger
3.4 mm
[0.118 to
0.133 inch]
Single Trigger
8203-026-700 Rev-AA
WIRE/PIN DIAMETER
(S)
(M)
1.1 to
1.6 mm
[0.043 to
0.063 inch]
2.4 to
3.0 mm
[0.094 to
0.118 inch]
3.4 to
3.8 mm
[0.133 to
0.150 inch]
www.stryker.com
(L)
1.6 to
2.0 mm
[0.063 to
0.079 inch]
2.8 to
3.2 mm
[0.110 to
0.126 inch]
3.8 to
4.2 mm
[0.150 to
0.165 inch]