Grease Filters - Broan best KER222 Manual Del Usuario

All manuals and user guides at all-guides.com
MAINTENANCE

Grease Filters

The grease filters should be cleaned fre-
quently. Use a warm detergent solution. Grease
filters are dishwasher safe.
To take off the grease filters: at the handle, push
the stop inwards and pull the filters downwards.
Hood Cleaning
Stainless steel is one of the easiest materials to keep clean. Occasional care will
help preserve its fine appearance.
Cleaning tips:
Hot water with soap or detergent is all that is usually needed.
Follow all cleaning by rinsing with clear water. Wipe dry with a clean, soft cloth to
avoid water marks.
For discolorations or deposits that persist, use a non-scratching household
cleanser or stainless steel polishing powder with a little water and a soft cloth.
For stubborn cases, use a plastic scouring pad or soft bristle brush together with
cleaser and water. Rub lightly in direction of polishing lines or "grain" of the stain-
less finish. Avoid using too much pressure which may mar the surface.
DO NOT allow deposits to remain for long periods of time.
DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere
to the surface causing rust.
DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to
remain in contact with stainless steel for extended periods. Many of these com-
pounds contain chemicals which may be harmful. Rinse with water after expo-
sure and wipe dry with a clean cloth.
Painted surfaces should be cleaned with warm water and mild detergent only.
OPERATION
Controls
The hood is operated using the (5) push-buttons
located at eye-level, on the front edge of the
hood.
The light switch turns the halogen lights on
and off. The blower on-off / speed 1 switch
turns the blower on to its lowest running speed.
Turn the blower off by pressing this switch a
second time. The blower speed 2 switch turns
the blower on to medium-low running speed.
Pressing this switch a second time sets a timer
which keeps the blower operating at this speed for 10 minutes.
The LED will blink during this time and the blower will shut off automatically.
The blower speed 3 and blower speed 4 switches operate the same as blower
speed 2 switch except: Blower speed 3 is medium-high and blower speed 4 is high.
At the end of each working time of 30 hours, all the leds blink at the same time; this
indicates that the grease filter need to be cleaned.
Once the clean grease filter are on, push one of the three speed switches to make the
count down start again.
LIGHT
SWITCH
BLOWER
ON-OFF /
SPEED 1
0-1
- 6 -
GREASE FILTERS
BLOWER
SPEED 2
BLOWER
SPEED 3
BLOWER
SPEED 4
LED LED LED LED
2 3 4