Johnson Controls YORK VIR-25A Instrucciones De Instalación página 9

Economiser assembly, standard configuration
���������������
�
The outdoor air damper is at the top. Confront the economiser with the frame of the corresponding
VIR unit. To fasten use the screws, nuts and washers 1 supplied. To install said screws 1 , first
remove the side panels 2 .
Outdoor air at the bottom
Remove supports 3 from the economiser and fit them on the opposite side, as shown in the
figure. Then turn the unit fully around. For coupling to the VIR indoor unit, proceed as in the standard
configuration.
�
Fig. 1
�
Fig. 2
GB
�
�������
���
�������
���
�
������
���
������
���
9