Cleaning The Airless Spray Gun; Servicing; General Servicing; High-Pressure Hose - WAGNER SUPER FINISH 17EX Manual De Instrucciones

Super Finish 17ex
8.4
CLEANING THE SPRAY GUN
You can find detailed information in the opera-
ting instructions for the spray guns.
1. Rinse the spray gun with a suitable cleaning agent under
lower operating pressure.
2. Clean the tip thoroughly with a suitable cleaning agent so
that no suitable coating material rests remain.
3. Clean the outside of the spray gun thoroughly.
3
AirCoat spray gun
Removal
1. Screw the grip (2) out of the gun housing. Pull out the inser-
tion filter (3).
2. If the insertion filter is clogged or defective, replace it.
Installation
1. Slide the insertion filter (3) with the longer cone into the
gun housing.
2. Screw the grip (2) into the gun housing and tighten it.
2
9

SERVICING

9.1

GENERAL SERVICING

We strongly recommend having an annual
check carried out by technicians for safety
reasons. Please observe all the applicable na-
tional regulations.
You can servicing of the unit carried out by
the Wagner Service. Favourable conditions
can be agreed with a service agreement and/
or maintenance packages.
Minimum check before every startup:
1. Check the hoses and spray gun with rotary joint for dam-
age.
2. Check whether the pressure gauge can be read.
Check at periodical intervals:
1. Check inlet and outlet valve according wear. Clean it and
replace worn out parts.
2. Check all filter inserts (spray gun, suction system) clean it
and replace if necessary.
9.2

HIGH-PRESSURE HOSE

Inspect the high-pressure hose visually for any notches or
bulges, in particular at the transition in the fittings. It must be
possible to turn the union nuts freely. A conductivity of less
than
1 MΩ must exist across the entire length.
The risk of damage rises with the age of the
high-pressure hose.
Wagner recommends replacing high-pres-
sure hoses after 6 years.
CLEANING THE UNIT / SERVICING
GB
45