PRECAUTIONS
•
Do not charge the transceiver and battery pack when they are wet.
•
Ensure that there are no metallic items located between the transceiver and the battery
pack.
•
Do not use options not specifi ed by KENWOOD.
•
If the die-cast chassis or other transceiver part is damaged, do not touch the damaged
parts.
•
If a headset or headphone is connected to the transceiver, reduce the transceiver
volume. Pay attention to the volume level when turning the squelch off.
•
Do not place the microphone cable around your neck while near machinery that may
catch the cable.
•
Do not place the transceiver on unstable surfaces.
•
Ensure that the end of the antenna does not touch your eyes.
•
When the transceiver is used for transmission for many hours, the radiator and chassis
will become hot. Do not touch these locations when replacing the battery pack.
•
Do not immerse the transceiver in water.
•
Always switch the transceiver power off before installing optional accessories.
•
For safety reasons, we recommend that the battery charger be connected to an easily
accessible AC socket.
Turn the transceiver power off in the following locations:
•
In explosive atmospheres (infl ammable gas, dust particles, metallic powders, grain
powders, etc.).
•
While taking on fuel or while parked at gasoline service stations.
•
Near explosives or blasting sites.
•
In aircrafts. (Any use of the transceiver must follow the instructions and regulations
provided by the airline crew.)
•
Where restrictions or warnings are posted regarding the use of radio devices,
including but not limited to medical facilities.
•
Near persons using pacemakers.
•
Do not disassemble or modify the transceiver for any reason.
•
Do not place the transceiver on or near airbag equipment while the vehicle is
running. When the airbag infl ates, the transceiver may be ejected and strike the
driver or passengers.
•
Do not transmit while touching the antenna terminal or if any metallic parts are
exposed from the antenna covering. Transmitting at such a time may result in a high-
frequency burn.
•
If an abnormal odor or smoke is detected coming from the transceiver, switch the
transceiver power off immediately, remove the battery pack from the transceiver, and
contact your KENWOOD dealer.
•
Use of the transceiver while you are driving may be against traffi c laws. Please
check and observe the vehicle regulations in your area.
•
Do not expose the transceiver to extremely hot or cold conditions.
ii