Publicidad
Idiomas disponibles
Idiomas disponibles
begin to search for active Bluetooth
equipment in range.
Select the appropriate BH Module
from the list displayed on the iOS
device to pair. Open the Pafers app to
run it.
ANDROID
(compatible Android devices)
This
monitor
Bluetooth 4.0 module.
Download a Pafers App from Google
Play (Check compatible apps at the
BH
website:
Turn Bluetooth to "ON" in settings on
the Android device. Open the Pafers
app to run it. When prompted by the
app, select the appropriate BH Module
from the list displayed on the Android
device to pair.
EMERGENCY STOP.-
For the user's maximum safety, this
unit is equipped with a safety key (g)
and a STOP button. The safety key (g)
must be slotted into its housing (E),
Fig.2, otherwise the machine will not
start.
When you are using the machine
always clip the cord on the safety key
to your clothing. Tugging on the cord
will pull the safety key out of its slot
and the machine will stop immediately.
To restart the machine simply put the
key back into the key slot.
Remove the safety key (g) whenever
the machine is not being used and
keep it out of children's reach.
Pressing the red button marked STOP
will also stop the unit immediately.
To restart it, press the button marked
START again.
ELEVATION.-
The
inclination
OPERATION
has
an
integrated
www.bhfitness.com).
function
operates
independently of all other functions.
Each time that you set switch (L) to
position I, as described in the Starting
section, Fig.1. the inclination level that
was last used will be displayed.
If inclination is not at zero when the
START
key
exercising, the machine will zero itself
while it is starting.
You can adjust the elevation level by
pressing the INCLINE▲ or INCLINE▼
keys to specify a value of 0 to 15,
depending on how you would like to
do the exercise.
Important:
inclination level of your treadmill by
propping it up on objects.
IMPORTANT:
LEVEL MUST BE AT ITS LOWEST
SETTING
BEFORE
TO PUT THE TREADMILL INTO THE
FOLDED POSITION.
PULSE
INSTRUCTIONS – USE.-
PULSE Hand-grip.
On this model the pulse rate is
measured by placing both hands on
the sensors (R), located on the
handlebar, as shown in Fig.3 and Fig
4.
When both hands are placed on the
sensors the heart symbol on the right-
hand side of the screen, marked
PULSE, will begin to flash and after a
few seconds a heart rate reading will
be displayed.
If both hands are not placed correctly
then the pulse function will not work.
If a «P» appears on the screen or the
heart symbol does not flash, make
sure that both hands are placed
correctly on the sensors.
12
is
used
to
Do
not
change
THE
INCLINATION
ATTEMPTING
MEASUREMENT
begin
the
Publicidad
