Working with the Equipment:
Do not place feet or hands
near or under rotating parts
when working. Risk of injury!
Observe the noise protection
and local regulations.
•
Switch on the motor according
to the instructions and only
when your feet are at a safe di-
stance from the cutting tools.
•
Do not use the equipment in the
rain, in poor weather, in a damp
environment, or on wet grass.
Work only in daylight or with
good lighting.
•
Do not work with the equipment
when tired, lacking concentra-
tion or under the influence of
alcohol or drugs. Always take
breaks in good time. Take a
sensible approach to the work.
•
When working, ensure a firm
stance, particularly on slopes.
Always work across the slope,
never upwards or downwards.
Take particular care when chan-
ging the direction of travel on
the slope. Do not work on ex-
cessively steep slopes.
•
Run the equipment only at a
walking pace. Take particular
care when turning the equip-
ment around, pulling it towards
you or going backwards.
•
Switch on the equipment ca-
refully and in accordance with
the directions in these instruc-
tions. Ensure sufficient distance
between feet and the rotating
blades.
•
Do not tilt the equipment when
starting other than if it is ne-
cessary to do so when starting
up in long grass. In this case,
tilt the equipment by pressing
down the handle bar such that
the front wheels of the equip-
ment are raised. Always check
that both hands are in the wor-
king position before returning
the equipment to the ground.
•
Do not work without the grass
bag or collision guard. Keep
away from the ejection hole at
all times.
•
Do not start the motor while
standing in front of the dischar-
ge duct.
Caution! Danger! The blade
continues to run after swit-
ching off.
There is a risk of injury.
•
The equipment is not to be
lifted or transported while the
motor is running. Switch off
the equipment if it has to be
tilted in transit, when crossing
surfaces other than grass, and
when the equipment is being
transported to and from the
surfaces to be mowed.
•
Always keep the grass ejection
hole clean and clear. Remo-
ve cut material only when the
equipment is stopped.
•
Do not leave the equipment
unattended in the workplace.
•
Do not work with equipment
that is damaged, incomplete,
or has been modified without
the authorisation of the ma-
nufacturer. Do not use the
GB
21