Assembly; Assembling The Curved Handle; Operation; Mounting / Removing The Grass Catcher - Grizzly Tools ERM 1637-3 Stow Traducción Del Manual De Instrucciones Original

GB
9 Front wheels
10 Housing
11 Cutting height adjuster
12 2 carrying handles
13 Connection cable
14 Cable holder
15 Cable strain relief
16 Power inlet
17 Release button
18 Mulch kit

Assembly

Disconnect the plug before any
work on the equipment. There is a
risk of injury.

Assembling the Curved Handle

Install lower bar:
1. Open the lower bar (4) and
move it to the desired inclinati-
on.
2. Fix the lower bar by means of
the pre-mounted quick-release
levers (6). There are three pos-
sible positions.
Mounting the bow-type
handle:
3. Fasten the bow-type handle
(1) with the enclosed screws,
washers and quick-release le-
ver (3) to the right and left of the
lower bar (4). Two positions are
possible.
4. Clipping in the cable holders
Clip the cable holders (14) onto
the bar to fix the machine cable
(13) in position
24

Operation

Attention: Do not operate the ap-
pliance until the collision guard
and grass catcher are fully in-
stalled. Risk of injury!
Mounting / removing the grass
catcher
1. Lift the collision guard (5).
2. Place the grass catcher (7) on
the mounting bracket (24) pro-
vided at the back of the lawn
mower.
3. Lower the collision guard (5)
onto the grass catcher (7) - it
will keep it in place.
4. To remove the grass catcher
(7), lift the collision guard (5)
and unhook the grass catcher
from the mounting bracket. Flap
down the collision guard to the
housing.
On emptying the grass catcher
also refer to section "Disposal/en-
vironment".

Level gauge

The level gauge is located on the side of
the grass catcher. The aerodynamic air
guidance provided by the flap also opti-
mises the filling
Flap open:
grass catcher empty
Flap closed:
grass catcher full