Trouble Shooting
Problem
Equipment does
not start
Motor stops
Result unsatis-
factory or motor
labours
Blade fails to
turn
Strange noises,
rattling or vibra-
tions
Replacement parts/Accessories
Spare parts and accessories can be obtained at
If you have any other questions, contact the "Service-Center" (see "Sercice-Center").
Possible Cause
Power is off
Defective start lever (
release button (
Worn carbon brushes
Defective motor
Grass too long
Blockage by foreign object
Cut height too low
Blade (
20) blunt
Blade area blocked
Blade (
20) assembled in-
correctly
Blade (
20) blocked by
grass
Blade screw (
21) loose
Blade screw (
21) loose
Blade (
20) damaged
www.grizzly-service.eu
Fault Fixing
Check the socket, cable, wire and
plug and have any repairs carried
out by an electrician
2) or
17)
Repair by customer services
Set a greater cut height. Lift the
front wheels slightly by pressing
down on the handle bar.
Remove the foreign object
Set a higher cut height
Have the blade sharpened or
replace it
Clean the equipment
Install the blade correctly
Remove the grass
Tighten the blade screw
Tighten the blade screw
Replace the blade
GB
29